15 — How to Make Deep Reach C Clamps All Wood only $10 Extreme Strength
е:
Detailed plans available here:
Tools we use or have reviewed in our shop:
Link to the KFW Community Woodworking group. Share pictures of your work & get help if needed. Join our King’s Fine Woodworking Community Page. Woodworkers helping other woodworkers. Share advice, get project ideas. Free tips. Insider information. Get the best deals on lumber & tools:
If you would like to help support our channel, there are a number of ways. One way is direct support through Patreon:
Another is by purchasing plans you might need on our website:
You can also help without spending anything, just by liking and sharing our videos. Thank you for your support. We love teaching the world to do woodworking.
These are by far the strongest all wood clamps I’ve ever seen on YouTube. They are stronger than the deep reach clamps made by Matthias Wandel & John Heisz, (that was a challenge guys ). And mine don’t have any metal in them!
Here is the Tap & die set I used for this job:
You can make these 12” deep reach C-Clamps with amazing strength for only $10.00! I was about to buy some for a project but the quality ones I found were $107.00 online, so I did some research and decided to make mine.
I studied some material properties, and of all domestics, oak has the second highest modulus of elasticity behind only hickory. With over 1.8 million pounds/sq.in. Modulus of elasticity defines the relationship between stress and strain, and effectively measures stiffness. The exact property you want in the arm of a clamp. I also found a study done with Fine Woodworking Magazine & Case Western Reserve University in 2007 measuring glue bond strengths. It utilized 6 glue types and different species of wood, 162 joints tested in all. Among the domestics, red oak combined with type 1 PVA glue (Titebond), had by far the greatest bond strength.
So, it was a no-brainer. Oak, is cheap as a hardwood. You can buy #2 common, because narrow sizes are all that is needed. And, many people have oak offcuts hanging around.
I did buy a 36” maple dowel for the screw thread. It was a 1-1/2” diameter. You could certainly turn one. But for me this was easier. And one dowel makes 2 clamps.
I made 2 clamps with the intention of testing them to destruction, but I didn’t have a strong enough scale. After I get one and do that, I think I’ll make 10 for my shop, and I’ll have paid less than buying a single one online.
I did cut all the threads and tapped the clamp. This is easy to do.
Detailed plans are available on my website if you are interested in duplicating these.
NOTE: Matthias Wandel, and John Heisz are both fantastic woodworkers. Very intelligent and very creative. If you haven’t seen their work, you should definitely check out their channels.
Matthias Wandel:
John Heisz: Источник видео youtube.com/watch?v=wd16ZC_evTE